Edel 35
- Boat REF# · 20705
- LOA · 10.60m
- Year · 1989
- Construction · GRP
- Underwater profile · Multihull
- Berths · 8
- Engine · 2 x petrol 9.9hp, Yamaha AEX x2 (1999)
- Lying · Eastern Algarve
This boat is off the market but here are some boats that are still For Sale
Extra Details
| Designer | Maurice Edel |
|---|---|
| Builder | EDel Strat France |
| Lying | Eastern Algarve |
| Fuel capacity | 100.0 ltr Total - 4 Tanks |
| Water capacity | 240.0 ltr Total - 3 Tanks |
Mechanical
| Engine | 2 x petrol 9.9hp |
|---|---|
| Engine make and model | Yamaha AEX x2 (1999) |
| Engine Hours | Not Recorded |
| Engine Cooled | Direct |
| Steering | Wheel |
| Drive | Shaft |
| Prop(s) | Three Blade |
| Fuel consumption (approx) | 2.0 ltr /hour At Cruising Speed |
| Cruising speed (approx) | 4.5 knots |
| Max speed (approx) | 6 knots |
| Engine spares |
|---|
Solar panels x 2
Dimensions
| LOA | 10.60m |
|---|---|
| LWL | 10.03m |
| Beam | 6.02m |
| Draft Min | 1.00m |
| Displacement | 3,500kg |
| Headroom | 1.78m |
| Storage | On marina |
Rig
Sloop rigged Z Spars Aluminium spars (1989) with stainless steel standing rigging (2004)
Sails
| Mainsail | Crusader - Slab (1999) |
|---|---|
| Headsail | - Furling (1999) |
| Other sails | Cruising Chute (1999) |
| Spare Genoa () | |
| Storm Jib () |
Mast and boom are Z-spars aluminium. Mast 13m, boom 6m. There are two winches to the mast, jamming cleats for halyards and reefing lines. Tri-colour/anchor light, VHF aerial and wind transducer at top of mast.
Standing rigging is 8mm stainless steel, fractional rig. There are two cap shrouds, forestay to a bridle and mast stays via a spreader. This rigging was replaced in 2004 and substantially stronger fittings than standard were used to the mast for the shrouds and forestay. There is a Lewmar mainsheet traveller at the rear of the cockpit and jib sheet travellers either side of the nacelle. The roller furler system is Plastimo 901. There are 2 x Barient two speed self tailing sheet winches and one small winch for the furler. The rig is light to handle, easy to reef and either one of us can sail the boat single handed. Mainsail: 41.5m² cruising quality sail with 7 full length battens to Frederikson low friction ball race slider system, new 1999. Genoa: 25.5m² cruising quality roller furling genoa, new 1999. U/v strip replaced 2004.
Electrical Systems
12 volt battery, 3 batteries charged by: wind generator, solar panels, shore power 2 domestic 130amps- 1xengine
Construction
| Construction | GRP |
|---|---|
| Underwater profile | Multihull |
| Finish | Paint finish |
The construction material is GRP, solid below the waterline and to 30cm above. The hulls above this, decks and nacelle are GRP foam sandwich. There are buoyancy chambers under each berth forward and aft.
The two hulls are identical and are joined by 3 substantial aluminium beams fixed by alloy clamps using M14 high tensile stainless steel bolts. The nacelle contains the centre cabin and cockpit areas and forms a safe walkway forward to the mast and anchor lockers. The hulls have keels for good windward performance and skegs to support and protect the rudders. The keels are reinforced to take the ground.
Accommodation
| Total # of berths | 8 |
|---|---|
| No. of double berths | 4 |
| Cabin(s) | 3 |
| Handbasin | 2 |
| Shower | 2 |
| Heads | 2 heads (Manual) |
The current owners bought the boat in 1996 in the South of France and brought it to the South of England by truck. They sailed the boat to Hull on the East coast of England where it was hauled out from September 1997 to April 1999 and made many improvements. These included:
• Reinforcing the keels and fitting a hardwood plate to the base of each keel with glass and epoxy.
• Awlgrip epoxy system below the waterline for prevention of osmosis (replaced again in 2006) – professionally applied.
• Awlgrip paint system to topsides. (repainted again in 2006 using Awlgrip system) – professionally applied.
• New steering arms, tillers, cables and conduit
• New electronic instruments
• Complete re-wiring, new interior lights and navigation lights. Wind and water generators fitted.
• Replacing standing rigging (replaced again in 2004)
• Fitting opening hatches to aft cabins
• Fitting 2 x new 9.9 Yamaha 4-stroke outboard motors and mounting/lifting system and fuel tank mounting outside of the cockpit.
• Refurbishment of interior (Refurbished again in 2006)
• All new sails
• New guardrails and lifelines.
• New cleats and backing plates.
All the fixed windows were replaced in 2002
2 burner gas cooker/stove
Accommodation
| Cooker/stove | |
|---|---|
| Grill | |
| Oven | |
| Sink | |
| Refrigerator | |
| Curtains | |
| Manual water system | |
| Non-Smokers |
The current owners bought the boat in 1996 in the South of France and brought it to the South of England by truck. They sailed the boat to Hull on the East coast of England where it was hauled out from September 1997 to April 1999 and made many improvements. These included:
• Reinforcing the keels and fitting a hardwood plate to the base of each keel with glass and epoxy.
• Awlgrip epoxy system below the waterline for prevention of osmosis (replaced again in 2006) – professionally applied.
• Awlgrip paint system to topsides. (repainted again in 2006 using Awlgrip system) – professionally applied.
• New steering arms, tillers, cables and conduit
• New electronic instruments
• Complete re-wiring, new interior lights and navigation lights. Wind and water generators fitted.
• Replacing standing rigging (replaced again in 2004)
• Fitting opening hatches to aft cabins
• Fitting 2 x new 9.9 Yamaha 4-stroke outboard motors and mounting/lifting system and fuel tank mounting outside of the cockpit.
• Refurbishment of interior (Refurbished again in 2006)
• All new sails
• New guardrails and lifelines.
• New cleats and backing plates.
All the fixed windows were replaced in 2002
2 burner gas cooker/stove
Deck Gear
| Sail cover | |
|---|---|
| Cockpit cover | |
| Sun awning | |
| Warps | |
| Fenders | |
| Boathook |
2 halyard winches
2 sheet winches
3 anchors
(CQR-Manson "CQR type", Brittainy "Danforth type")
40.00m of chain
35.00m of warp
Mc Hypalon 2.6 dinghy (2006)
3hp outboard, Yamaha (2004)
Anchor 2 has 20m chain and 35m warp
Nav Equipment
| Compass | |
|---|---|
| Speed | |
| Log | |
| Wind | |
| VHF | |
| GPS | |
| Autopilot | |
| Clock | |
| Barometer | |
| Navigation lights | |
| Echo sounder |
Safety Equipment
| LPG Detector | |
|---|---|
| Liferaft | |
| Life jackets | |
| Life buoys |
2 bilge pumps (2 manual / 0 Electric)
Broker's Comments
This boat has been viewed and photographed by Russell of Boatshed Algarve. Register or log in to see more photos of this boat. These boat details are subject to contract.
Low and sleek lines from this perfromance cruising catamaran, plenty of spac in either boom, with seperate access providing privacy for multiple occupation. Good centre saloon with ample galley very clean allround haveing been cared for lovingly by the current owners, who have cruised with her extensivley all around the world. Simply a very nice example of a vessel ideal for family and freinds yet still abel to out perform most single hull vessels around.
Note: Offers
Linha baixas e finas as vindas deste catamaran, com espaço e acesso separado para providenciar privacidade para qualquer ocupação. Um salão central muito bom e uma cozinha tambem ampla, muito limpo em todo o lado notando-se o carinho com que foi ratado pelos seus actuais donos, que ja correram o mundo neste simples e muito bonito exemplo de barco. Um barco ideal para familia/amigos e pronto para navegar ao lado dos seus primos com um só casco.